Skip to main content

LLMark

Usage Instructions

  1. Ensure the surface of the material is clean, dry, stable and free from oil/grease.
  2. Shake the can for a minimum of 2 minutes.
  3. Lay the material on a clean piece of card or paper. The work surface must be free from dust.
  4. DO NOT use near any electrical device or source of combustion. The work environment MUST be well ventilated.
  5. Hold the can approximately 250mm from the product at an approximately 45 degree angle and moving the can from left to right spray an even coat to cover the desired mark area only. Be sure not to coat the material too thin or too thick. Only one coat is required.
  6. Allow to dry for 3 minutes with room temperature approximately 21c. Drying times may be extended in colder environments. The drying time can be accelerated by using heat or placing the material in a warmer environment.
  7. Laser engrave in raster mode. For best results use a 2”f/l lens at minimum 500dpi resolution. Laser parameters will vary depending on the make and model of your machine but typically, good results are achieved using power of 100w at a raster speed of 100-150mm/sec. We HIGHLY recommend you perform a test to ascertain the ideal settings for your machine before main production. Feel free to contact our technical dept for help with parameter settings appropriate to your specific laser machine.
  8. Wash the product under clean running water and dry with a soft cloth

Warning: Highly Flammable. Contents under pressure. Do not pierce, crush or burn canister. Keep out of eyes and avoid inhalation.